Difference between revisions of "Toner Transfer"

From OpenCircuits
Jump to navigation Jump to search
Line 18: Line 18:
  
 
* [http://diycircuits.net/makepcb/pcb_making Toner transfer Using Matte Paper - by Hilary Cheng]
 
* [http://diycircuits.net/makepcb/pcb_making Toner transfer Using Matte Paper - by Hilary Cheng]
 +
 +
[[Category:Howto]]

Revision as of 03:46, 24 June 2007


Press-and-Peel(tm), photoresist, Sharpie, nail polish...

I have used this method for etching some fairly fine lines when fabricating a microstrip microwave filter using Tom Gootee's method linked to below. My two cents on this is the fact that the type of toner you use matters. In an admittedly small sample set of two different printers, the genuine HP microfine toner performed far better than the generic toner that was installed in a second printer that we tried. We used the Staple's glossy inkjet paper, and with the HP toner, it worked quite well.

Also, the etching solution of 1 part muriatic acid to 2 parts hydrogen peroxide is worlds better than the ferric chloride solution as it is clear and doesn't stain everything it touches. It is also available locally (hydrogen peroxide is in every drug and grocery store, muriatic acid can be found at almost any hardware store).

Thankfully, we worked in a school lab that had access to pure acetone for cleaning off the traces, so we didn't have to resort to foul-smelling nail polish.

External Links