Difference between revisions of "Sun Tracker or Irrigation Timer to drive motors"
m |
|||
| Line 8: | Line 8: | ||
[[File:Irrigation_Timer_Sun_Tracker_motor_driver.png]] | [[File:Irrigation_Timer_Sun_Tracker_motor_driver.png]] | ||
| + | [[File:Sun_Tracker_Board_Layout.png]] | ||
| − | I made a simple trickle charger and voltage-reduction circuit | + | I also made a simple trickle charger (below) and voltage-reduction circuit |
to power my motors and above circuit directly from the solar panels | to power my motors and above circuit directly from the solar panels | ||
instead of plugging them into a wall outlet DC power supply. I am using an | instead of plugging them into a wall outlet DC power supply. I am using an | ||
Revision as of 09:07, 26 September 2016
This is using two LEDs to sense the sun and send +- or -+ logic signals to a full bridge motor driver like L298 or http://www.redrok.com/led3xassm.htm LED3X schematic. I bought his. I recommend it.
I changed the front end logic to 4060 and 4011 ICs here, for fun. You could use this circuit to turn on an irrigation motor for a very short time every several hours (just omit the sun sensor and select appropriate timing pins and much lower oscillation frequency for the 4060).
File:Irrigation Timer Sun Tracker motor driver.sch
File:Irrigation Timer Sun Tracker motor driver.kicad pcb
File:Sun Tracker Board Layout.png
I also made a simple trickle charger (below) and voltage-reduction circuit to power my motors and above circuit directly from the solar panels instead of plugging them into a wall outlet DC power supply. I am using an almost dead car battery.
File:DC Solar to 15vdc+trickle charge.kicad pcb File:DC Solar to 15vdc+trickle charge.sch
