Difference between revisions of "Sun Tracker or Irrigation Timer to drive motors"

From OpenCircuits
Jump to navigation Jump to search
m
Line 1: Line 1:
 
This is using two LEDs to sense the sun and send +- or -+ logic signals to a full bridge motor driver like L298 or http://www.redrok.com/led3xassm.htm LED3X schematic. I bought his. I recommend it.  
 
This is using two LEDs to sense the sun and send +- or -+ logic signals to a full bridge motor driver like L298 or http://www.redrok.com/led3xassm.htm LED3X schematic. I bought his. I recommend it.  
  
I changed the front end logic to 4060 and 4011 ICs here, for fun. You could use this circuit to turn on an irrigation motor for a very short time every several hours (just omit the sun sensor and select appropriate timing pins and much lower oscillation frequency for the 4060).
+
I changed the front end logic to 4060 and 4011 ICs here, for fun. The circuit turns on a motor for 3 seconds once every 44 seconds to move the solar panels. You could use this circuit to turn on an irrigation motor for a very short time every several hours (just omit the sun sensor and select appropriate timing pins and much lower oscillation frequency for the 4060, since 3 seconds every 44 seconds is not long enough for irrigation).
  
 
[[File:Irrigation_Timer_Sun_Tracker_motor_driver.sch]]
 
[[File:Irrigation_Timer_Sun_Tracker_motor_driver.sch]]

Revision as of 09:18, 26 September 2016

This is using two LEDs to sense the sun and send +- or -+ logic signals to a full bridge motor driver like L298 or http://www.redrok.com/led3xassm.htm LED3X schematic. I bought his. I recommend it.

I changed the front end logic to 4060 and 4011 ICs here, for fun. The circuit turns on a motor for 3 seconds once every 44 seconds to move the solar panels. You could use this circuit to turn on an irrigation motor for a very short time every several hours (just omit the sun sensor and select appropriate timing pins and much lower oscillation frequency for the 4060, since 3 seconds every 44 seconds is not long enough for irrigation).

File:Irrigation Timer Sun Tracker motor driver.sch

File:Irrigation Timer Sun Tracker motor driver.kicad pcb

Irrigation Timer Sun Tracker motor driver.png

SolarTrackerBoard.png

I also made a simple trickle charger (below) and voltage-reduction circuit to power my motors and above circuit directly from the solar panels instead of plugging them into a wall outlet DC power supply. I am using an almost dead car battery.

DC Solar to 15vdc+trickle charge.png

File:DC Solar to 15vdc+trickle charge.kicad pcb File:DC Solar to 15vdc+trickle charge.sch