Difference between revisions of "Raspberry Pi Mounting Platform and Bracket Pictures"
Russ hensel (talk | contribs) |
Russ hensel (talk | contribs) |
||
| Line 1: | Line 1: | ||
These are actual prints of the mount described in [[Raspberry Pi Mounting Platform and Bracket]] | These are actual prints of the mount described in [[Raspberry Pi Mounting Platform and Bracket]] | ||
| + | |||
| + | This page has several pictures of the printed parts discussed in [[Raspberry Pi Mounting Platform and Bracket]] | ||
| + | |||
| + | There are some different variations of the part, and some are shown with additional parts mounted and some without. Pictures are taken from different angles. | ||
| + | |||
| + | This is an article started by Russ Hensel, see "http://www.opencircuits.com/index.php?title=Russ_hensel#About My Articles" '''About My Articles''' for a bit of info. The page is only partly finished | ||
| + | |||
= Small Platform With Voltage Regulator = | = Small Platform With Voltage Regulator = | ||
| + | |||
| + | Here a voltage regulator and usb power output port are mounted on top of the Pi. The blue and white wires are for a power supply to run the regulator and thus the Pi. In this case I needed a basic supply to run two stepper motors and wanted to use the same power source for the Pi. | ||
[[Image:Pp3.JPG|500px]] | [[Image:Pp3.JPG|500px]] | ||
| − | + | This is from the side with the hdmi port | |
[[Image:Pp small1.JPG|500px]] | [[Image:Pp small1.JPG|500px]] | ||
| − | |||
| Line 16: | Line 24: | ||
[[Image:Pp small4.JPG|500px]] | [[Image:Pp small4.JPG|500px]] | ||
| − | |||
= image placeholders = | = image placeholders = | ||
Revision as of 14:12, 11 January 2018
These are actual prints of the mount described in Raspberry Pi Mounting Platform and Bracket
This page has several pictures of the printed parts discussed in Raspberry Pi Mounting Platform and Bracket
There are some different variations of the part, and some are shown with additional parts mounted and some without. Pictures are taken from different angles.
This is an article started by Russ Hensel, see "http://www.opencircuits.com/index.php?title=Russ_hensel#About My Articles" About My Articles for a bit of info. The page is only partly finished
Contents
Small Platform With Voltage Regulator
Here a voltage regulator and usb power output port are mounted on top of the Pi. The blue and white wires are for a power supply to run the regulator and thus the Pi. In this case I needed a basic supply to run two stepper motors and wanted to use the same power source for the Pi.
This is from the side with the hdmi port
This is from the side of the Pi with its IO headers
image placeholders
Arduino Over a Pi
Large Platform No Componets
This is a large platform with a mounting bracket. It is bad because the normal top mount will cover the Raspberry Pi pins. Still can be used, Access the pins another way, cut into it or bottom mount it. For bottom mounts the legs need not bee so long.
