Part Design Pad and Pocket

From OpenCircuits
Jump to navigation Jump to search

Introduction

FreeCad has a new version .17. I am in a bit of a struggle with it and thought rather than just complain I would write a bit about it and try to help other overcome any problems with it. So here goes:

This is an article started by Russ Hensel, see "http://www.opencircuits.com/index.php?title=Russ_hensel#About My Articles" About My Articles for a bit of info. The page is only partly finished, it may or may not ever be finished.


Questions

Part Design Primitives

  • How does order matter
  • Use booleans on them
  • Adding a Part Workbench part.
  • Using with pad and pocket
  • Shetch, if not attached to top of culinder then how do I drill a hold part way thru. -- russ do example.