MPPT Solar and Wind Power Boost Charge Controller

From OpenCircuits
Revision as of 05:46, 25 June 2012 by 173.206.64.134 (talk)
Jump to navigation Jump to search

The [1] is a preliminary circuit idea to match a low voltage solar or wind turbine input to a higher voltage battery. An analogue circuit will measure incoming current and voltage inputs to set the maximum power point tracking (MPPT) and boost the output voltage up to charge a higher, or equal voltage, battery. Input voltage range: 9v through 60v. Output battery voltages: 9v through 60v. MPPT will work only if the battery is higher than the input source. Otherwise, the circuit will act like a direct connection, source to output. It is based on the LTC3703 boost converter.

http://www.youtube.com/watch?v=Xw7ehax3330 http://www.youtube.com/watch?v=TX_G_rVwgFM http://www.youtube.com/watch?v=xZDHSsTVJvM http://www.youtube.com/watch?v=crSkmrQavXg http://www.youtube.com/watch?v=HLdK_ghbQs4 http://www.youtube.com/watch?v=yejH6Rw2khM http://www.youtube.com/watch?v=KjyXH7R807E http://www.youtube.com/watch?v=upfmckiKWhI