GM862 SMD Connector
|Line 11:||Line 11:|
Revision as of 13:00, 28 January 2006
This is the Molex SMD connector that interfaces to the GM862 Cellular Modules. If you're prototyping with the GM862, you pretty much have to have one of these. Watch out, it's 0.5mm pitch, 50-pin, SMD connector. You can solder it by hand, but you'll need some experience, solder wick, and a decent iron. You can also reflow it with a hot-plate and a stencil. If you're not comfortable soldering it, there are breakout boards and designs available from SFE.
Molex Connector Footprint and Spec Sheet
The dimension stuff can be found on page x of the hardware datasheet.
Molex part # : 53748-0504
GM862 Cellular Module
Original Creator: --Sparkfun 12:08, 26 January 2006 (PST)