Difference between revisions of "Fastening Objects in 3D Printing"

From OpenCircuits
Jump to navigation Jump to search
(Created page with "= Introduction = = Why Fasten = = How to Fasten = = Links =")
 
Line 1: Line 1:
 
= Introduction =
 
= Introduction =
  
 +
Fastening parts can involve a variety of issus:
 +
 +
*Parts need to go together and come apart
 +
*Parts print better in parts because of support needs or other issues, then need to be put together, perhaps permanently.
 +
*Parts are too big for printer.
 +
*Parts need only to go together once, the fastening is permanent.
 +
*Parts need to be assembled or disassembled without tools.
 +
*Cost is of importance.
 +
*Joints should/should not be visible.
 +
 +
Depending on the issues there are different methods that you may wish to apply.
  
 
= Why Fasten =
 
= Why Fasten =

Revision as of 11:10, 6 January 2018

Introduction

Fastening parts can involve a variety of issus:

  • Parts need to go together and come apart
  • Parts print better in parts because of support needs or other issues, then need to be put together, perhaps permanently.
  • Parts are too big for printer.
  • Parts need only to go together once, the fastening is permanent.
  • Parts need to be assembled or disassembled without tools.
  • Cost is of importance.
  • Joints should/should not be visible.

Depending on the issues there are different methods that you may wish to apply.

Why Fasten

How to Fasten

Links