Difference between revisions of "Das Brewmeister!"

From OpenCircuits
Jump to navigation Jump to search
(link to page with more details; spelling)
 
Line 11: Line 11:
 
http://www.blug.linux.no/files/presentations/freebeer/paper.pdf
 
http://www.blug.linux.no/files/presentations/freebeer/paper.pdf
  
My approach would be similar I think I may be able to get by with modifications to Spark Fun's toaster controller and a  "cluged" together wireless temp sensor.  I have prototyped in a breadboard a 16F88 with the DS18S20 one wire digital temperature sensor and one of Spark Fun's old Smirf's.  Proto board passes data fine, even wrote a quick VB program to dump data in to Access for later.
+
My approach would be similar I think I may be able to get by with modifications to Spark Fun's toaster controller and a  "cluged" together wireless temp sensor.  I have prototyped in a breadboard a 16F88 with the DS18S20 [[one wire]] digital temperature sensor and one of Spark Fun's old Smirf's.  Proto board passes data fine, even wrote a quick VB program to dump data in to Access for later.
 
----
 
----
 
===PCB Conversion===
 
===PCB Conversion===

Latest revision as of 09:06, 31 October 2014

Project Scope[edit]

Description:
This is an attempt to mimic the control systems used in commercial brewing of beer. It has been done before with some external hardware and a refrigerator + heat lamp see:

http://www.blug.linux.no/files/presentations/freebeer/paper.pdf

My approach would be similar I think I may be able to get by with modifications to Spark Fun's toaster controller and a "cluged" together wireless temp sensor. I have prototyped in a breadboard a 16F88 with the DS18S20 one wire digital temperature sensor and one of Spark Fun's old Smirf's. Proto board passes data fine, even wrote a quick VB program to dump data in to Access for later.


PCB Conversion[edit]

I thought that the conversion would be relatively simple. Just take what I had and draw, right? I used the free Eagle setup and dumped everything to BatchPCB.com (PCB Manufacturers#BatchPCB). A problem arose from changing to SMDs and trying to cut too many corners. I found out, after I had assembled a board, got bizarre voltage readings and no response from the pic,that the SMD voltage regulator I had put on the new PCB required a capacitor on the output. I wanted to keep the components to a minimum and didn't include everything from the prototype when I drew up the design. I will be more aware next time.


Coming Later?[edit]

I hope to have the new PCB in the next few weeks and if everything goes well I begin to look more closely at the reflow controller and procurement of a refrigerator. Meantime I need to find the time to actually begin brewing some beer!

Finally got something together at http://seidle.blogspot.com/ not really the project originally described but may be of interest none the less.