BitWacker Command GUI

From OpenCircuits
Jump to navigation Jump to search

Early Mock Up of Screen

Screen Shot

Notes:

Field lablels may include a note as to the data type to be entered:

  • (b) binary, eight characters 0's and 1's as 00101111.
  • (d) decimal, a normal decimal number

Command Details

These commands are fairly direct implementations of the basic command set of the BitWacker. The interface does change format of the input. For example in configuring the IO ports binary seems easier than decimal.


  • Reset ( Reset )
    • No input, no output, should just work.
  • Version
    • No input, output is the version response from the BitWacker.
  • Configure
    • 3 Inputs ( binary ) for the direction of PortA, PortB, PortC, and one input for Analog.

1 is input, 0 is output.

    • Output: none.
  • Output All ( )
    • 3 inputs, one field for each port. Binary input 1 for output high, 0 for output low.

Input All () No input. Output one field for each port, binary.

Output Pin 3 Inputs. Port use either decimal numbers 0, 1, 2, or A, B, or C. Pin, use decimal number 0 to 7. State 0 or 1 ( could be in any base, how can you tell? ).

Input Pin 2 Inputs. Port use either decimal numbers 0, 1, 2, or A, B, or C. Pin, use decimal number 0 to 7. Output, state of pin 0 or 1.

RC Servo As with Output Pin except that state is 0 to xxxxx ( decimal ) 0 for RC off, 1 for no rotation, xxxxx for full rotation.