Editing BitWacker Command GUI
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
− | + | Command Details | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
=== Early Mock Up of Screen === | === Early Mock Up of Screen === | ||
Line 19: | Line 5: | ||
[[Image:BW_SS.png | Screen Shot ]] | [[Image:BW_SS.png | Screen Shot ]] | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
=== Command Details === | === Command Details === | ||
Line 61: | Line 15: | ||
*Version | *Version | ||
− | ** | + | **No input, output is the version response from the BitWacker. |
− | |||
*Configure | *Configure | ||
− | ** | + | **3 Inputs ( binary ) for the direction of PortA, PortB, PortC, and one input for Analog. |
+ | 1 is input, 0 is output. | ||
** Output: none. | ** Output: none. | ||
Line 71: | Line 25: | ||
**3 inputs, one field for each port. Binary input 1 for output high, 0 for output low. | **3 inputs, one field for each port. Binary input 1 for output high, 0 for output low. | ||
− | + | Input All () | |
− | + | No input. Output one field for each port, binary. | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
+ | Output Pin | ||
+ | 3 Inputs. Port use either decimal numbers 0, 1, 2, or A, B, or C. Pin, use decimal number 0 to 7. State 0 or 1 ( could be in any base, how can you tell? ). | ||
− | + | Input Pin | |
+ | 2 Inputs. Port use either decimal numbers 0, 1, 2, or A, B, or C. Pin, use decimal number 0 to 7. | ||
+ | Output, state of pin 0 or 1. | ||
− | + | RC Servo | |
+ | As with Output Pin except that state is 0 to xxxxx ( decimal ) 0 for RC off, 1 for no rotation, xxxxx for full rotation. |