Editing SmartTerminal for Controlino
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 37: | Line 37: | ||
self.send_ctrls = [ ... | self.send_ctrls = [ ... | ||
</pre> | </pre> | ||
− | and add a clause to the if then | + | and add a clause to the if then like: |
<pre> | <pre> | ||
elif self.mode == "Controlino": | elif self.mode == "Controlino": | ||
Line 46: | Line 46: | ||
Run the SmartTerminal again, this time you will find the above commands loaded into the first several send areas as defaults. Try them out, all but "Controlino" respond with done. Invalid commands also seem to get no response. These commands look like they are supposed to have numbers appended as well, it would be nice if we had some values in place just to let you know what the expected form is. | Run the SmartTerminal again, this time you will find the above commands loaded into the first several send areas as defaults. Try them out, all but "Controlino" respond with done. Invalid commands also seem to get no response. These commands look like they are supposed to have numbers appended as well, it would be nice if we had some values in place just to let you know what the expected form is. | ||
+ | |||
= Try Blink = | = Try Blink = |