Infra Red Receiver Pinout

From OpenCircuits
Jump to: navigation, search

IR Recievivers typically have 3 pins. There are many many different part numbers and I have often not been able to find the spec sheets. Typically the output amp seems to have a load resistor to V+. The power drawn when powered by an ohmmeter is low so the resistance from V+ to ground is high. Finally they do not seem to be greatly harmed by reverse power.

So to determine pinout:

Measure the resistance between pairs of pins. Look for a resistance on the order of 20K ohms. The other pin is ground. Power up guessing as to the V+. Put a scope on the presumed signal pin and connect to a scope. Illuminate with a remote. If no response, reverse signal and V+ pins. Test again with scope. Should work now, and you know the pinout.

Personal tools
Namespaces

Variants
Actions
Navigation
Toolbox